200A and 202 reproduction
frames back
in stock.
I know the store is currently out of the offset preheat cups. So I thought I'd share how I make mine.

I start with a 3/4" copper pipe cap

And some 5/16", .014" wall brass tubing

A 5/16" drill bit...........

......and our cap chucked up in the vise, gives us a hole that will take the brass tubing, AND allow us to insert a 5/16" bolt onto which we will thread a nut.

Now we have a way to turn the cap in our tubing cutter. I aim for somewhere around a 1/2" to 5/8" deep cup. Sometimes the piece seems to walk in the cutter so it's never an exact science for me.

Now I'll take my tubing and using a tubing flare set make a single flare

Now I'll just gauge my cup and mark where to cut my tubing.

This is a tight enough fit that a gentle tap from a hammer may be needed to seat the brass into the copper.

And I'll usually pound the metal flush for a good tight fit

Solder, cup, and torch...........

Make sure to heat primarily the copper. The brass is super thin and will get hot all by itself.

A little dressing with a couple of files

Flattened the bottom out nicely.......

And it fits perfectly over a 200a generator. 


One of our German collectors friends with the appropriate skills and equipment had cups milled from flat aluminum plates. One version to slide over the generator and one version for the MilSpecs (Those are very popular with our collectors).
Here some pics:

My homepage: http://www.eschaefer.de
Pls. see navigation on HP for Collectors Maps.
Welcome to the Coleman Collectors Forum, an international forum of Coleman enthusiast and collectors, as such people from all over the world come here to read about Coleman collecting, repair, and to meet and make friends. The pages contained here are intended for the use of amateur collectors and people interested in Coleman collecting, restoration and repair as a hobby. It goes without saying to refrain from political posts, personal attacks and inflammatory posts.

Please note, all postings are the personal opinions of the members posting, the owner, administrators and moderators of the forum do not warrant the accuracy of posted information or endorse the safety of such.